SWIFT LIGHT-CURING LAMP, with orthodontic mode - Ref:576

The SWIFT light-curing lamp is battery-powered and operates wirelessly.

The light emission head rotates 360°.

The SWIFT lamp has two functions. One for conventional polymerisation of composites and the other for orthodontic bonding through a "boost" function where the power is pushed to 3000 mW/cm².

Switching from one operating mode to another with a simple switch. Total ease of use. Completely intuitive operation. The lamp is highly ergonomic.

The light beam emission head is very narrow. 13 mm in diameter. The light emission cone is very "tight", which increases the efficiency of the lamp and its action. 

Two operating modes in polymerisation mode, soft and normal. Power in soft mode at 1000 mW/cm², and 2000 mW/cm² in normal mode.

Soft mode lighting timers are 5 / 10 / 15 or 20 seconds. In normal mode, 1 / 3 or 5 seconds.

Each mode corresponds to a single output power level. (higher in normal mode than in soft mode)

For the orthodontic "boost" mode, the power is pushed to 3000 mW/cm². Here too, only one power level is possible.

In this mode, the lamp performs a light emission/pause cycle. The light emission lasts 3 seconds, followed by a light-off period of 2 seconds. You can set up to 8 consecutive on/off cycles.

The lamp is supplied with the lamp body including the battery, an eye protector, a charging base and its charger, light guide tip covers, the light guide, and a bag of single-use protective sleeves for the lamp.

The battery capacity is +/- 750 uses in soft mode for a duration of 10 seconds.

Wavelength of emitted light; 385 to 515 nm.

French-language instruction manual included,

Equipment guaranteed for two years, parts and labour included in accordance with our T&Cs (see the "Warranty" section), except for the battery which is guaranteed for six months.